Audi 80/Avant + Technical specification + Engines + System of production of the fulfilled gases + Cooling system + Fuel tank and fuel pump + Air filter and airintaking channels + System of injection + Coupling + Transmission and transmission + Suspension bracket and steering + Brake system + Anti-blocking system of brakes + Wheels and tires + Body electrical system + System of ignition + Lighting + Signalling devices + Devices and auxiliary devices + Heating and ventilation - Body elements Front bumpers Forward part of the car Cowl Wings Moldings Doors External rear-view mirrors Forward and back flew down Trunk lid at a sedan Back door of the versatile person Rear bumper Movable hatch Clearing of openings for a water drain Control of anticorrosive protection of the bottom of a body Salon Seats + Search of malfunctions + Specifications
|
Rear bumper
|
For removal of a rear bumper it is necessary to weaken on the right and left parties of the car on two six-sided bolts. On an illustration fixing bolts of a sedan are shown. |
|
If the trunk lid of a sedan knocks or sits incorrectly, it is possible to adjust the locking plate (3) behind at a floor of a luggage compartment. For this purpose it is necessary to weaken both screws (arrow). The locking plate becomes available after removal of a covering of loading edge (1) or after removal of a small cover (2) in a covering. |
Removal
|
- Version sedan: to cast away a rug of a luggage compartment.
- Version versatile person: to remove behind a door covering.
- To cast away a rug of a luggage compartment.
- To remove from clamps a lateral covering of a luggage compartment – only behind.
- Slightly to delay aside a lateral covering, to enter from above between a covering and a back wing a face key with the extender (length about 500 mm) with a replaceable head and Cardan and to put on it fixing bolts of a bumper.
- To turn out bolts.
-
All models: to turn out in a luggage carrier on the right and at the left on two six-sided bolts.
- To turn out on the right and at the left on two screws self-tapping screws connecting a bumper and the flap.
- To separate lateral faces of a bumper from body arms.
- For this purpose strongly to press a bumper sideways down and at the same time to delay it for the upper edge from a body.
- To remove a bumper, raising on both ends over flaps.
- At installation of a bumper at first to insert back fastenings.
- At first to insert lateral faces of a bumper into arms on a body bottom edge. Then to press them sideways above that also the top fixing points were recorded. To watch for fixing brackets on bottom edge of a bumper.
- To lift flaps over the ends of a bumper and to connect them bolts.
-
Versatile person: regulation of a bumper on height is made by moving of fastening of a bumper. The distance between bottom edge of lateral back wings and a bumper has to make 6,5–7,5 mm
|
|
|
|