Audi 80/Avant (B4)

since 1991-1995 release

Repair and operation of the car


Audi 80/Avant
- Technical specification
   Engines
   Transmissions
   Body
   Chassis
   15-inch wheels
   Brake system
   Seats
   Passive safety
   Full drive
   Distributive Torsen-differential
   Dynamics of the movement at a dry paving
   Instructions on operation for all-wheel drive cars
   Blocking of differential of the back bridge
   Motor compartment
   Regular servicing
   Organization of a workplace
   Lubricant works
   Oil consumption
   Right choice of engine oil
   Replacement of engine oil and oil filter
   Check of level of working liquid of the power steering
   Check of level of oil of a mechanical transmission
   Check of level of oil in the drive of the back bridge
   Control of the ATF level in an automatic transmission
   Check of level of oil in the main transfer of an automatic transmission
   Replacement of ATF
   Greasing of hummock drives, hinges and locks
+ Engines
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ System of injection
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrical system
+ System of ignition
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications




Greasing of hummock drives, hinges and locks

The plan of service of Audi provides only a few lubricant works on a car body. However life shows that periodic greasing helps to remain legkokhodny to some places of a body, from among what usually creak, get stuck, are torn or rust. Thus it is necessary to consider the following basic rule: hinges with narrow passes to which plastic greasing gets with great difficulty, it is better to oil or lubricant spray. It is better to grease the rubbing open surfaces with jellied greasing because these greasings keep better.

Doors and trunk lid

 PERFORMANCE ORDER

  1. Door Audi hinges do without servicing. But after all it is better to grease them with a small amount of oil from time to time.
  2. It is better to grease small rychazhka of door stoppers of the lower door hinge with universal jellied greasing.
  3. Locks of doors, covers of a luggage compartment or the fifth door it is possible to process aerosol greasing.
  4. You can spray trunk lid hinges a small amount of oil.

Locking cylinders

  • At least before a cold season it is necessary to sprinkle with the spray isolating and deleting a rust in a lock cut.
  • It greases, forces out humidity and protects in the winter from a rust, and also freezing.
  • It greases, forces out humidity and protects in the winter from a rust, and also freezing.

Cowl

Into place, where the hummock drive leaves a cover, to put a little plastic greasing and to involve a cable in a cover by means of repeated pressing the lever. If on your car there is a 5-cylinder engine, for carrying out this operation it will be necessary to uncover a radiator.

 PERFORMANCE ORDER

  1. The locking pins of a cowl and both closing the lever of a cover of a cowl need to be greased with a small amount of plastic greasing or to apply the greasing spray.
  2. Hinges of a cowl and its latch should be oiled or lubricant spray.

Hatch

 PERFORMANCE ORDER

  1. Directing to process a small amount of a lubricant aerosol.
  2. To watch that lubricant means did not get on an upholstery of the hatch and a ceiling.
  3. To remove excess greasing.