Audi 80/Avant (B4)

since 1991-1995 release

Repair and operation of the car



Audi 80/Avant
+ Technical specification
- Engines
   Basic elements
   Lubrication system
   Ventilation of a case
   Visual check of the engine
   Running in of the new engine
   Engine service life
   Nominal and maximum frequency of rotation
   Restriction of frequency of rotation
   Measurement of pressure of compression
   List of malfunctions
   Provorachivaniye of the engine
   Hydraulic pushers
   Works on the GRM gear belt
   List of malfunctions
   Removal and installation of a head of the block of cylinders
   Removal and installation of the engine
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ System of injection
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrical system
+ System of ignition
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications





Nominal and maximum frequency of rotation

The internal combustion engine reaches the maximum power with a certain frequency of rotation – the so-called nominal frequency of rotation. The set of bigger number of turns does not give a prize on power. He can serve good service unless for switching on the following, highest transfer.

It is quite possible to call our engines steady against the increased rotation frequency. The drive of valves is carried out by means of dish-shaped pushers directly from the camshaft located above. Thus only the small masses that allows to develop the high frequency of rotation without danger to the drive of valves are set in motion.

Turns of the engine can be lifted to about 6300 rpm only for a short time. The engine then considerably "growls" that is caused by fluctuations of a cranked shaft in its bearings.