Tension of a maple belt
By moderate pressing by a thumb on maple the belt can be pressed through it between two pulleys as follows:
|
Engine
|
Maple a belt for
|
Sagging of a belt under pressing of a thumb, near
|
|
4-cylinder to Saint. 91 g.
|
generator
|
10 mm
|
|
All 4-cylinder
|
water pump, pump of the hydraulic booster
|
5 mm
|
|
All 4-cylinder
|
conditioner compressor
|
5 mm
|
|
The 5-cylinder
|
generator
|
5 mm
|
|
The 5-cylinder
|
pump of a gidrousislitel
|
5 mm
|
|
The 5-cylinder
|
conditioner compressor
|
5 mm
|
If the belt is established new maple, it is necessary to check its tension approximately through 100 km and if necessary to dozatyanut; new belts are first extended more strongly.
Tension of a poliklinovy belt
- Poliklinova a belt of the 4-cylinder engine of the model which is let out after September 91g., at control it is necessary to pull anew. So it is necessary to weaken a belt and to establish a tension according to the scheme described in the following paragraph.
- Poliklinova the belt of the 6-cylinder engine always has the correct tension thanks to the automatic device of a tension.
|