Audi 80/Avant (B4)

since 1991-1995 release

Repair and operation of the car


Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ System of injection
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrical system
+ System of ignition
- Lighting
   Lighting check
   Spare lamps
   Replacement of lamps
   Removal of headlights
   Check of adjustment of headlights
   Fog lights
   Independent installation of fog lights
   Indexes of turns
   Back lamps
   Illumination of registration plates
   Other illuminants
   Illumination of the dashboard
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications




Illumination of the dashboard

The boss and the glow lamp of lighting of devices make a whole. On an illustration the lamp is turned out (arrow).

At the left: three small bulbs are responsible for lighting of regulators of heating (3, 4 and 5). For replacement to separate the rotary switch (1), to weaken bolts (shooters) and to remove the panel (2).

On the right: illumination of a motor compartment: to squeeze a little from sides the top part of the lamp (1) and to take out it from grooves. Then there is available a sofitny lamp.

Illumination of an ashtray and lighter:

1 – the built-in panel;
2 – six-sided bolt;

3 – bulb.

The block of illumination of a ware box on an illustration is presented entirely pulled out from fastening (1)

2 – connecting wire;
3 – bulb;

4 – button.

Illumination of devices

Here only illumination of devices is considered. About the indicators which are also located in a combination of devices you will read in the head Pribory and auxiliary devices.

 PERFORMANCE ORDER

  1. To remove a steering wheel (the head Podvesk of wheels and a steering).
  2. To remove the block of a combination of devices (the head Pribory and auxiliary devices).
  3. Behind on a combination of devices to turn the boss of a lamp of illumination of devices to the left and to take out it.
  4. Lamps with a glass socle form a whole with the boss.
  5. Again to insert a cartridge with a lamp into the block of a combination of devices and to turn to the right against the stop.

Posvetka of the heater panel

 PERFORMANCE ORDER

  1. To remove handles of three rotary regulators of system of heating and ventilation.
  2. To turn out the located lower than two screws with crosswise shliyets. To remove the panel.
  3. Now three bulbs with glass socles are visible.
  4. Bulbs can be got from the boss on one.

Illumination of an ashtray and lighter

 PERFORMANCE ORDER

  1. To take out plug-in part of an ashtray.
  2. To turn out a long face key a six-sided bolt behind the lighter.
  3. To turn the built-in panel of the lighter and to take out a cartridge of a lamp from the lower party.
  4. To get from the boss a lamp with a glass socle.
  5. At the cars equipped with additional devices, the lighter is located near the lever of the parking brake.
  6. For replacement of lamps to remove back part of the central console.
  7. Illumination of the lighter at the car with additional devices: to remove the tsetralny console.

Illumination of a ware box

The plafond of illumination of a ware box contains the contact switch in one case. Food arrives only at the turned-on dimensional light or light of headlights.

 PERFORMANCE ORDER

  1. On a reverse side of a ware box to turn a 4-watt bulb of an incandescence to the left (it is necessary to reconstruct the representation: the lamp shows on the course forward) and to extend up (the bayonetny castle device).
  2. For removal of all block to separate plugs and to squeeze out a cartridge from fastening towards salon.

Illumination of the indicator of the AKP mode

For illumination of the indicator of the AKP mode on the selector lever at the included ignition the lamp with a glass socle serves (1,2 W, a DIN form W).

 PERFORMANCE ORDER

  1. To remove the central console, see the section Salon.
  2. To unscrew a cartridge of a bulb from the AKP selector lever console.
  3. To take out a bulb with a glass socle from the boss.

Illumination of additional devices

 PERFORMANCE ORDER

  1. To remove the central console, see the section Salon.
  2. To turn to the left cartridges of lamps on a reverse side of the block of additional devices and to remove them.