Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
+ System of injection
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrical system
+ System of ignition
- Lighting
Lighting check
Spare lamps
Replacement of lamps
Removal of headlights
Check of adjustment of headlights
Fog lights
Independent installation of fog lights
Indexes of turns
Back lamps
Illumination of registration plates
Other illuminants
Illumination of the dashboard
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications
|
Indexes of turns
Replacement of lamps
|
|
- Models with 4-and 5-cylinder engines: dexterous hands are one of conditions of success of this work.
- To remove a front grille on the left side (at models with the 5-cylinder engine).
- Depending on what engine costs on your car, at first it is necessary to disconnect a rubber earring on the right block headlight, to wring out both fixing buckles back and to extend up a middle part of a cap (where it costs, it will be necessary to remove still in addition an air inlet sleeve). To disconnect external part of a covering (screws with crosswise shliyets, from above).
- If all of you do not reach yet, it is necessary to remove a block headlight.
- Models with the 6-cylinder engine: to weaken a bolt with crosswise shliyets at the block headlight case.
- To disconnect a headlight; it is built in a fog light by two fixing ledges.
- All models: to turn a little a lamp socle to the left and to extend back.
- To press a little the glow lamp into a socle, to turn on the left and to take out.
- Installation: to insert a cartridge into the case of the index and to turn to the right against the stop.
|
|
Removal of the case of the index of turns
Models with 4-and 5-cylinder engines
|
|
- If necessary to remove a block headlight.
- To turn out a cartridge of a lamp.
- To squeeze fixing uvulas of the case of the index towards the boss.
- To push out the case of the index of turns forward.
- For installation of the case of the index of turns carefully to implant fixing uvulas into the headlights directing on the case and to record.
|
|
|
|
Wires (1) for retrofitting by fog lights are already laid. They are brought (arrow) below to an adjusting opening which becomes available after removal of a forward slip (2). |
|
|
For separation of the case of the index of turns from the case of a block headlight (1) at models with 4-and the 5-cylinder engine it is necessary to squeeze fixing uvulas (shooter) towards the boss and to pull out the case from directing on the headlight case (the position 2 shows lower). |
|
|
Models with 4-and the 5-cylinder engine:
1 – boss of a lamp;
2 – lamp case.
|
|
|
Models with the 6-cylinder engine:
1 – lamp case;
2 – external glass of the index of turn.
The arrow shows on one of fixing ledges by which the case of indexes of turn is installed in the case of fog lights. |
|
|
