|
Malfunction
|
Its reason
|
Than to help
|
| A. Coupling slips |
1. Overlays of coupling are worn-out
2. Insufficient effort of pressing of coupling
3. Overlays of coupling are greasy
4. Coupling overheated |
To replace the conducted disk
To replace press a disk
To replace the conducted disk and a defective sealing epiploon of a transmission or a cranked shaft
To replace faulty details |
| B. Coupling does not separate |
1. Air in the hydraulic drive of coupling
2. A beating of the conducted disk
3. The deformed conducted disk or the broken slip
4. The conducted disk clamps on a transmission shaft
5. After very long parking the slip prirzhavet to a flywheel
6. Tangential flat springs of a press disk are broken |
To replace a faulty detail, to pump over
To correct or replace the conducted disk
To replace the conducted disk
Properly to clean melkoshlitsevy connection by a wire brush.
In summary to grease with paste or Moly spray
To include the first transfer and to put a starter in order that earned the engine in action, constantly to press a coupling pedal. Sharply to press a pedal of an accelerator and right there to release to release coupling. Otherwise to dismantle
To replace press a disk |
| C. Coupling is not separated and at the same time "conducts" |
The coupling disk is worn-out press |
To replace press a disk |
| D. Coupling pulls |
1. Malfunction of the engine or knots of fastening of a transmission
2. Roughnesses of a surface of a prileganiye of a flywheel or press disk
3. Wrong slips |
To replace the bearing of the engine or knots of fastening of a transmission
To replace a faulty detail
To replace the conducted disk |
| E. Coupling noise |
1. An imbalance of a press disk of coupling or the conducted disk
2. Defective spring of a quencher of tortional fluctuations
3. The bearing is faulty vyzhimny
4. Rivet connections in coupling are weakened
5. The needle bearing in a back end face of a cranked shaft is faulty |
To replace press a disk of coupling or the conducted disk
To replace the conducted disk
To replace vyzhimny the bearing
To replace press a coupling disk
To replace the needle bearing |