Audi 80/Avant (B4)

since 1991-1995 release

Repair and operation of the car


Audi 80/Avant
+ Technical specification
+ Engines
+ System of production of the fulfilled gases
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and airintaking channels
- System of injection
   + System of injection of Mono-Motronic
   + System of injection of Digifant
   - System of injection of KE-III-Jetronic
      Basic elements
      Operating procedure
      Lambda regulation
      Malfunctions and independent diagnostics
      Independent repair
      Visual check
      Check of separate elements
      Search of malfunctions
      Removal of components
      Check of the mode of idling and analysis of exhaust gases
      List of malfunctions
   + Systems of injection of MPI and MPFI
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Anti-blocking system of brakes
+ Wheels and tires
+ Body electrical system
+ System of ignition
+ Lighting
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ body Elements
+ Search of malfunctions
+ Specifications




System of injection of KE-III-Jetronic

Multipoint injection

The engines equipped with system of injection of gasoline pull together clean air. In addition to it the system of injection doses fuel for each cylinder. At models it happens to the 5-cylinder engine constantly (kontinuierlich) and control of this process is exercised electronically (elektronisch) therefore our system of injection received the name KE-III-Jetronic.

Principle of action

The initial form of this system of injection, K-Jetronic, worked hard purely mechanically by the principle "inlet air – a lot of fuel". And such simple devices as the regulator of enrichment of gas mixture at warming up of the engine and the starting valve, in addition provided a prisposablivayemost to difficult service conditions. It was impossible to combine a lambda regulation (with adjustable catalytic converter) with classical K-Jetronic system without additional devices.

This circumstance served as the main reason for further development of KE-Jetronic. Basic elements of former system remained and were added with the electronic control unit and the so-called regulator of pressure – the regulator which is in addition influencing fuel dispensing with the electromagnetic drive. The regulator of pressure is active mainly during warming up of the engine, however it also carries out the central function at regulation of composition of gas mixture through a lambda regulation (adjustable catalytic converter).

Together with completely electronic system of ignition of "VEZ" (the System of ignition is considered in the head) this system of injection represents a full control system of the engine. Though each system is supplied with own control unit, between them there is a data exchange. Besides, as information sources for systems of ignition and injection the same sensors often serve.

The store of malfunctions which is writing down malfunctions during the movement finishes possibilities of electronics. Memory of the store of malfunctions can be interrogated for establishment of the reason of malfunctions.